As far as I know, when I need to edit multiple nodes to a desire coordinate, I have to select each of the nodes and input the value one by one, as Staad manage Relative Move only. It would be efficient just to select all the nodes, and type a coor...

Add the ASME-STS-1 2021 file as an option for the results of the analysis. There are only four equations from ASME, then everything defaults to AISC 2016, so most of the work is done.

According to the code and standard practice, stiffness reduction for DAM applies for Required Strength analysis, but for Design Strength calculation and for Service check, nominal stiffness is to be used. To be able to indicate Staad which combina...

SAMPLE BUCKLING LENGTH ALLOWABLESTRESS MEMB LY(m) LZ(m) UNL(m) KY KZ UNF FA(N/mm2) FT(N/mm2) FCZ(N/mm2) 1001 1.000 2.000 1.000 1.000 1.000 1.000 93.400 156.670 138.250 1002 2.500 5.000 2.500 1.000 1.000 1.000 93.400 156.670 138.250 1003 4.000 8.00...

When designing concrete members in Staad.Pro, detailed design information can be seen in batch mode using TRACK command. One useful detail is the design ratio Pu/Pn. If that value can be shown the same way is shown for steel design it can speed up...

Add the concrete design code for environmental structures into STAAD for designing water retaining structures.

Please prepare a UC summary table Profile size wise, Group Wise from ejoumale.pajamale@technipenergies.com

It is painful task to add DJ1 and DJ2 for deflection check in design paramter. Instead create SPAN command , which allows to add a set of members in a SPAN command to calculation local y and z deflection and actual DFF against allowable DFF. This ...

It shall be noted that, if solids are not oriented properly than, we are not able to assign properties to the model, and it is difficult to see which the bod is solid. -- With Regards. Ankur Jain -- Model Attached is confidential.

I think it is a good idea to allow users to name their Tapered sections as with the prismatic sections or sections created by user table. Because many times user creates many tapered sections in his model, andt when it comes to modifying one of th...