Please inform the date of release of staad pro/RCDC for Design of Various type of Ground Level and Overhead Water tanks as per IS3370

As shown in the attached screenshot, the STAAD program does not display the load list envelope numbers, which causes inconvenience for users. Please improve this feature.

There is currently no way, other than directly adding rigid body members with the necessary releases, to simulate an an axial angle or tee member (brace) under eccentric axial load. This causes a high amount of manual calculations to determine the...

In staad foundation designing, hoped that desinger can specify any bar diameter and spacing when configuring rebar, rather than selecting the diameter and spacing provided by the software. It is a very useful feature. Other software can also achie...

I am suggesting STAAD to implement new features for users, which will make the users use a short time in steel design. 1. As we know, sometimes we may have a secondary beam where this beam will create a node in the primary beam. Now, to make the s...

Sometimes these drawings are sent to other colleagues that do 3D modeling, and sometimes do not know that W200x27 TEE === WT100x13. It would be an improvement for the Schedule of Sections and MTOs show the correct WT callout, when a STAAD users sp...

Please allow option to save drawings from AutoDrafter to PDF.

There is currently no way to create a base plate plan in AutoDrafter. Please add it.

It is only possible to create a plan/section by selecting a member at that location, and must be in the plane of either a plan or section. MTO take-off "drawing" only shows table - a great addition would be to add the isometric view of the structu...

Some layers in autodrafter clog up the view of the drawing (e.g., member centerlines). It would be great if layers can be turned on/off within AutoDrafter Drawing Style Manager.