Because you must create multiple wind definitions for wind along a single direction (i.e. windward, leeward, sidewall) it would be helpful to have the ability to combine these in a single load case. Combining them in the load combos is cumbersome....

There is the command NSF that modifies the net area of the whole member, but there isn't a command to modify the net area of the tension flange only to apply it to section F13 in AISC.

Good morning Srs. I would like to control tolerance ratio Steel- utilization ratio.

Please refer to the snapshot attached. The OSLoadUI::CreateLoadEnvelop function name is wrong. Please update in the next releases. Initially I could not find this function in the intellisense (by typing Create and left me wondering) and hence I am...

Report generation is significantly improved in the latest version. it will be great, If user able get the beam & column design details like , grade of concrete, member size, reinforcement required, reinforcement provided etc. in an table forma...

I am testing Load.GetUDLLoads command. The contents of the returned D1Array will always be 0. For example, 1992 UNI 0.100 7.750 10.250, since 7.750 is not returned in D1Array,I can not check the range which the load is applied . D2Array truely ret...

In the current AIJ2005 code allowable stress calculation of STAAD.Pro, the Young's modulus is fixed at 205000 (N/mm2). On the other hand, in the AIJ2002 code, by using the YNG=1 parameter, the Young's modulus used in the frame analysis can be use...