I think that the numbering on Load Group, Primary Load Case and Load combination spreadsheet should be customizable. This is very important when dealing with several design parameter and/or analysis load groups.

Currently saved report setups are only available to the model it was saved in. The user should have the ability to load a report template that he created that can be used for any job.

Addition of partition wall load on slab should be added on analytical model in Staad Pro Connect Edition

The way like STAAD physical has it now allows to create only one by one panels with pressure redistribution only in x or Z direction. Just inclined members in the attached sketch cannot be loaded with parallel or perpendicular directions. Also it ...

Iam designing a reinforced concrete ramp as a plate,the difficult iam facing is there is no BS 8110 in analytical design,and with the available BS 8007 i cant check deflection of the plate.

The following improvements should be made to Staad Pro 1.The automatic generation of wind load should be made available to Indian code also apart from American code.It will save lot of time in analysis and manual calculation. 2. Automatic creation...

Option for adding wall load (partition wall) as line load direct on slab should be added

I want to design this kind of steel truss in Staad Pro Connect Edition, should i run analysis in staad space or staad plane which one is correct?

May you add an option for choosing the strength stirrups in RCDC,by default is 250 but when i want to use stirrup of 410 its not possible to change its strength in RCDC

Quantities of block work, sand, gravel, cement and their cost estimates and price quotes in different currencies with updates for currency exchange.