Please consider adding an autosave feature. A real autosave not a prompt that appears every so often minutes asking you to save. One that will autosave without input. Autosave is pretty much a standard now across a variety of softwares, so constan...

Within the Annotation Menu, could you include Plates Stresses & Nodal Forces ? This will be very useful to display specific plate /nodal results during compilation of Structural reports. Given that the contours only show a range of values. Thi...

This might be difficult to implement, but it might be nice if you could label the node numbers in the physical modeler different than used in the analytical modeler so that you could keep those nodes the same. Therefore, they would show up the sam...

It is hoped that the API SPEC 4F standard can be added, and the wind load can be quickly loaded in 45°, 135°, and so on.

When completing a design in RCDC if the member fails, you cannot edit the rebar. I would like to be able to edit reinforcement. Then after the reinforcement is added, I would like it to print a full report so I can see what is failing. This is so ...

It should work similarly to code checking steel members according to EN 1993-1-1. It would benefit everyone designing aluminum structures due to highly corrosive environments and/or weight restrictions.

These could be used when performing member or shell design in STAAD.Pro, as well as Advanced Concrete design. See applicable snapshots attached. User would like to be able to do design to NZ codes in STAAD.Pro (specifically concrete and timber,...

at present in the 'Translational repeat' command we have the option to 'link elements' so as to create new 'beam' elements... - could we expand this feature so that: 1) translational repeating a line (parallel to its local X axis) can have the pos...

dear teams,please make corrects for software when you design water tank with slab including beams,RCDC not reading beams,plz correct it,thanks in advance