While generating Report, Company Logo needs to be changed for every project, that is a tedious practice. The changes should be permanent and for company.

Provide a method for defining surfaces which curve out of plane so that they can be used to create curved walls

We request to at the OpenSTAAD function to renumber Nodes just like we do with beams.

Currently, it is possible to display results for multiple design blocks with AISC360-16 results only. This feature is also required for AIJ2005 and 2002. In AIJ codes, load cases are classified into parmanent loads, temporary loads and loads for...

When you open a Section from the Properties panel by double-click, you are prompted to the same Table, including section type as the one you double-clicked. That is OK. But the table is just opened regardless of what section size or configuration ...

The pipelink transfer of loads from AutoPIPE to STAAD is currently very limited for guide-type supports and other multi-direction supports. A guide support will have vertical loads as well as lateral loads. Depending on the direction of the latera...

To streamline the design process using the OpenSTAAD function, we aim to automate the visualization of member stress ratios for each analysis. Currently, when employing the "objOpenSTAAD.View.SetModeSectionPage 1, 6, 19" function, the stress ratio...

Within the Annotation Menu, could you include Plates Stresses & Nodal Forces ? This will be very useful to display specific plate /nodal results during compilation of Structural reports. Given that the contours only show a range of values. Thi...

This might be difficult to implement, but it might be nice if you could label the node numbers in the physical modeler different than used in the analytical modeler so that you could keep those nodes the same. Therefore, they would show up the sam...

It is hoped that the API SPEC 4F standard can be added, and the wind load can be quickly loaded in 45°, 135°, and so on.